Skip to content

Know every line of your repair before we start

(559) 552-7713
(559) 552-7713
Technician crouched beside a gray car door tapping out a dent with a knockdown tool and hammer under a striped LED dent light, PDR rods racked on the shop wall

ServicesDent Repair

Dent Repair in Sanger

A dent can be a quick fix or a panel that needs real bodywork, and you deserve to know which before anything is touched. We look at your car, explain the method that fits, and put the scope in writing first.

The right fix depends on the paint and the metal

Most dents fall into two camps. If the paint is unbroken and the metal has not stretched too far, we can often use paintless dent repair: we work the panel back into shape from behind with specialized rods and tools, so your factory paint stays on the car. If the paint is cracked or chipped, or the dent sits on a sharp body line or a panel edge, the repair needs conventional bodywork, filler where appropriate, and refinishing.

We tell you which camp your dent is in and why. That answer goes on the written estimate along with what we plan to do, so you are not surprised by a paint charge after the panel is already open.

What our dent repair covers

Paintless dent repair
For door dings, shallow dents and many hail marks where the paint is intact. We reach behind the panel, or use glue-pull tabs where there is no access, and massage the metal back out slowly. No sanding, no filler, no new paint.
Conventional dent repair
When the metal is creased or stretched, we pull and shape it, apply a thin skim of filler only where it is needed, and prime and block-sand the area smooth before paint.
Paint matching and refinishing
If a repair needs paint, our shop is PPG certified, and we mix and blend the color into the surrounding panels so the repaired spot does not stand out in sunlight.
Trim and panel removal
Getting behind a dent often means taking off door cards, taillights or inner liners. We remove and reinstall them carefully and replace any one-time-use clips.
A walk-around when you pick up
We show you the finished panel under good light so you can check the repair with us before you drive away.

Signs a dent is worth fixing now

  • Cracked or chipped paint at the dent

    Once bare metal is exposed, rust can start under the paint and spread. Fixing it early keeps the repair smaller.

  • A crease along a body line

    Sharp creases stretch the metal and get harder to correct if more damage piles on. They usually need bodywork rather than paintless methods.

  • A door, hood or trunk that closes differently

    If a panel now sticks, rattles or shows an uneven gap, the dent may have bent a hinge area or inner structure. That is worth a closer look, and sometimes it points to collision repair rather than a simple dent fix.

  • Several small dents after a storm

    Scattered round dents across the roof and hood are typical hail damage. Many can be fixed paintlessly, and it may be worth checking your comprehensive coverage before you decide.

  • You plan to sell or trade in

    Visible dents lower what buyers and dealers offer, and small paintless repairs are often a modest cost compared with the difference.

How a dent repair goes at our shop

  1. 1

    Look at the damage together

    You bring your vehicle in and we inspect the dent under shop lighting, checking the paint, the depth, and whether we can reach the back of the panel.

  2. 2

    Written estimate before any work

    We write down the method, the parts or trim that need to come off, whether paint is involved, and the factors behind the price. You decide with everything in front of you.

  3. 3

    The repair

    Paintless work is done by hand, a little at a time, checked against a reflection board until the panel reads flat. Conventional repairs move through bodywork, primer, paint and clear coat with cure time between steps.

  4. 4

    Reassembly and final check

    We reinstall trim, clean the car, and look the panel over again. If anything outside the written scope came up, we would have called you before doing it.

Estimator photographing a gray SUV's crumpled hood and bumper with a tablet as the owner watches, outside open body shop repair bays

What moves the price of a dent repair

Two dents that look the same size from the driveway can call for very different work. That is why we price yours only after seeing it, and why the written estimate names each factor below that applies to your car. You see how the number was built before we pick up a tool.

Whether paint is needed
When the finish is unbroken and paintless repair works, the job usually costs less than one that needs filler, primer and color matching.
Size, depth and location
A shallow ding in the middle of a door is simpler than a deep dent on a body line, a panel edge or near a roof rail.
Access behind the panel
Some dents can only be reached by removing interior trim, lights or liners. Others have bracing behind them that limits what tools can do.
Panel material
Many newer vehicles use aluminum hoods and fenders, which are less forgiving than steel and take more time to work.
Number of dents
Hail or parking-lot damage spread over several panels is priced by count and size, and we list it panel by panel.

Dent repair questions

Something not covered here? (559) 552-7713

Can every dent be fixed without repainting?

No. Paintless dent repair works when the paint is not cracked and the metal has not stretched too much. Deep creases, damaged paint and dents on sharp edges usually need bodywork and refinishing. We tell you which applies once we have seen it.

Will the repaired spot look different from the rest of the car?

With paintless repair no new paint goes on, so the finish you see is your original. When paint is needed, we mix the color to your car and blend it into the neighboring panels so the match holds up in daylight.

How long will my car be at the shop?

A handful of small paintless dents can often be finished fairly quickly. Repairs that need paint take longer, since each coat has to cure before the next step. The expected timeline is written on your estimate, so you know what to expect for getting around in the meantime.

Is it worth filing a claim for a dent?

That comes down to how the repair cost compares with your deductible and how the damage happened. Hail damage usually falls under comprehensive coverage. We can write up an estimate for you first, and if you decide to file, our insurance claims page explains how we work with your adjuster.

What if you find more damage once the trim is off?

Now and then a bent bracket or hidden crack turns up after disassembly. If it does, we pause, show you what we found and explain the change before any added work goes ahead.

Dark blue sedan parked on a concrete lot in front of open body shop bays with plastic-masked cars and tool carts inside

Find out what your dent really needs

Tell us about the dent and bring your vehicle by. We will look it over and give you a written estimate with the method and the price factors laid out before anything starts.